Table of Contents
Advertisement
Installation
Installing and Configuring the Software
Install the communication software according to the software
user's modem of the same COM port and IRQ line used by the
modem.
You may be prompted by the software to configure certain
communication parameters. We suggest the following settings:
Item
Suggested Setting
Baud rate
38400 bps
Data bits
8
Parity
none
Stop bit
1
Flow control
RTS/CTS
Initialization string
AT&F
Testing Your Modem
In order to check if the modem is functioning properly, make sure
that the COM Port and IRQ settings of the modem match the
software. Type AT on your terminal screen and press ENTER.
The modem should respond by displaying an OK (or 0). If it does
not, either the modem may not have been installed properly or
the software has not been properly configured.
4
Advertisement
Table of Contents
