Adjusting Kombimotor For User; Fitting And Adjusting The Shoulder Strap; Adjusting And Setting The Loop Handle - Stihl KMA 135 R Instruction Manual

English
1 2
► Insert the nuts (2) in the barrier bar (1) so that the holes
line up.
► Fit the clamp (5) in the loop handle (3).
► Place the loop handle (3) with clamp (5) and barrier bar (4)
on the shaft (6).
► Press the clamp (7) against the shaft (6).
► Insert screws (8) and tighten.

8 Adjusting KombiMotor for User

8.1

Fitting and Adjusting the Shoulder Strap

► Put on the shoulder strap (1).
► Adjust the shoulder strap (1) so that the carabiner (2) is
about a hand's width below your right hip.
12
3 4
5
6
7
8
1
2
Other approved carrying systems are listed in this User
Manual, @ 21.
8.2

Adjusting and Setting the Loop Handle

The loop handle can be set to different positions to suit the
height and reach of the user.
► Switch off the KombiEngine and remove the battery.
► Undo the screws (2).
► Move the loop handle (1) to the required position and
check that the following conditions are met:
– The bump guard (3) fits between the loop handle (1) and
carrying ring.
– a = no more than 25 cm.
► Tighten down the screws (2) so that the loop handle (1)
cannot be rotated on the shaft.
8 Adjusting KombiMotor for User
a
1
2
3
0458-687-0121-A