Installation, Maintenance, And Upgrade; Replace The Ssd - Cisco Firepower 1100 Series Installation Manual

Installation, Maintenance, and Upgrade

•
•

Replace the SSD

The Firepower 1100 series ships with an SSD installed. You can replace this SSD should it fail. Before
replacing the SSD, you must power off the chassis by pressing the power switch on the rear panel.
Caution You will lose your configuration after you replace the existing SSD with a new SSD.
Follow these steps to replace an SSD in the chassis:
Step 1
Loosen the thumb screws on both sides of the SSD bay and pull the existing SSD out of the bay.
Step 2 Insert the new SSD into the bay and push it in until it is seated.
Figure 25: Remove and Install an SSD
Replace the SSD, on page 35
Install the FIPS Opacity Shield in a Two-Post Rack, on page 36
C H A P T E R
Cisco Firepower 1100 Series Hardware Installation Guide
5
35