MTCAN_PREV|MTCAN_SYNC|MTCAN_SPEOD|MTCAN_CHKRDY|MTCAN_VAR|
MTCAN_SETSZ|MTCAN_SILI|MTCAN_SEEK|MTCAN_CMTYPEANY|MTCAN_COMPRESS,
/*minimum delay to I/O is 4 minutes, because when a retry is
*performed, the drive retries a number of times, and then
*rewinds to BOT, repositions, and tries again.*/
40, 4*60, 20*60, 5*60, 512, 64*512, 0, (u_char*)0 },
{ DATTAPE, TPDAT, 2, 6, "HP", "C1537A", 0, 0, {0},
MTCAN_BSF|MTCAN_BSR|MTCAN_APPEND|MTCAN_SETMK|MTCAN_PART|
MTCAN_PREV|MTCAN_SYNC|MTCAN_SPEOD|MTCAN_CHKRDY|MTCAN_VAR|
MTCAN_SETSZ|MTCAN_SILI|MTCAN_AUDIO|MTCAN_SEEK|MTCAN_CHTYPEANY,
/* minimum delay on i/o is 4 minutes, because when a retry is
* performed, the drive retries a number of times, and then
* rewinds to BOT, repositions, and tries again. */
40, 4*60, 4*60, 5*60, 3*3600, 512, 512*512,
tpsc_default_dens_count, tpsc_default_hwg_dens_names,
tpsc_default_alias_dens_names,
{0}, 0, 0, 0,
0, (u_char *)0 },
28
Silicon Graphics (SGI)
For IRIX 6.4/6.5:
For an explanation of the functions of the
"MTCAN and Constants Values" on page
3
Edit the first line of the entry to suit your tape drive:
For the HP C1537A, change the first line to read:
{DATTAPE, TPDAT,2,6,"HP","C1537A",0,...
For the HP C1557A, change the first line to read:
{DATTAPE, TPDAT,2,6,"HP","C1557A",0,...
For the HP C5683A, change the first line to read:
{DATTAPE, TPDAT,2,6,"HP","C5683A",0,...
For the HP C5713A, change the first line to read:
{DATTAPE, TPDAT,2,6,"HP","C5713A",0,...
4
For IRIX 5.x, remove
(shown in bold above).
5
For IRIX 5.x, change the blocking factor from
blocks) on the last line of the entry. This will keep data transfers short an
avoid tying up the bus.
MTCAN
from the fourth line of the entry
MTCAN_AUDIO
values and constants, see
30.
to
512*512
64*512
(64 KB