Getting Started
Inside the Box
Before you install the SR820ac Voice Gateway, verify that the following items are included in the box with
the SR820AC:
Power Adapter
Ethernet Cable RJ 45 (TAE)
You must have the latest service packs and patches installed on your computer for your operating system.
You will need a 75‐ohm coaxial cable with F‐type connectors to connect the SR820ac to the nearest cable
outlet. If a TV is connected to the cable outlet, you may need a 5 to 900 MHz RF splitter and two
additional coaxial cables to use the TV and the SR820ac.
Before You Begin
Take the following precautions before installing the SR820ac:
The SR820ac should always be put in a vertical upright position.
There should always be a clearance of at least 30 mm between each of the side covers and
any object that might block the air flow through the unit.
If the unit is attached by means of the comprised bracket, the FNC connector should
protrude on the left hand side when attaching the unit to the bracket.
Strive to deploy the unit in a central location of the livable areas where most of the wireless
devices are used.
Item
Description
Connect the SR820ac to an AC electrical outlet
Connect the SR820ac to PC or Notebook
14