Advertisement
IN THE BOX
Included:
a. Top Plate
b. Bottom Plate w/ Pre-installed Casters
c. Vertical Support Bars
d. Horizontal Support Bars
e. Transoms
f. Accessory Screws
g. Assembly Screws
PLEASE
NOTE:
Maximum load capacity for these racks is 1,000lbs.
Using a combined equipment weight that is heavier
than the max load indicated may result in instability
causing possible injury.
ASSEMBL Y
Lock the casters before starting assembly.
Make sure all knock-out holes are aligned along the
back side of your rack.
1. Attach the vertical support bars (c) to the bottom
plate (b) with the pre-installed casters using the
assembly screws (g).
2. Place the transoms (e) perfectly centered on the
vertical support bars (c). Attach with assembly
screws (g). See picture on cover. *
3. Place the horizontal support bars (d) in the lower
portion of your rack for additional stability. Use
assembly screws (g).
4. Attach the top plate (a). Use assembly screws (g).
5. If desired, install our ROY2247 side panels (sold
separately). Use assembly screws (g).
6. Customize your rack by adding accessories (sold
separately) that fit your components. Be sure to use
the accessory screws (f).
* Required for installing optional side panels. If you're not installing optional side panels, place transoms and horizontal support bars as desired. See diagram on page 2.
a.
c.
d.
e.
Standard Screw
Vertical Support Bars
b.
f.
g.
Fan Hole
Caster
Top Plate
Transom
Bottom Plate
Advertisement
