Ariens Apex 48 Operator's Manual page 14

7. Rotate discharge chute 180 degrees. See
Figure 5.
Figure 5
8. Place the discharge chute in the
operating position. Ensure holes are
aligned. See Figure 6.
Figure 6
9. Reinstall original hardware on each side
of discharge chute assembly. Install
spacer in upper hole and washer in lower
hole between mounting brackets. See
Figure 7.
1. Washer
2. Spacer
10. Remove two eccentric spacers, two
round head square neck bolts and two
locking nuts from hardware bag.
EN - 10
2
1
Figure 7