Documentation Errors - 3Com Router 3030 Release Note
Router 6000 series; router 3000 dsl series;
Hide thumbs
Also See for Router 3030:
- Installation manual (50 pages) ,
- Command reference manual (101 pages) ,
- Supplementary manual (31 pages)
Table of Contents
Advertisement
MPLS
Documentation Errors
Frame Relay Congestion Control BECN/FECN does not function. Disable IP Fast
Forwarding on the interface if Frame Relay Traffic Shaping is selected.
Frame Relay Traffic Shaping is Inactive on interfaces that use Frame Relay Traffic
Shaping. Disable IP Fast Forwarding on the interface if Frame Relay Traffic
Shaping is selected.
QoS with ip fast forwarding doesn't work properly. Disable ip fast forwarding.
If you ping a CE Router from a PE Router within an MPLS/BGP L3 network there
will be no response. Use the command
, using the source address of the PE interface that is in the
xxx.xxx.xxx.xxx
VPN of the intended target.
If Loopback0 and LSR ID ip addresses are different, MPLS LDP will not work
properly. Match Loopback0 and LSR ID ip addresses
Command Reference Manual' IS-IS section text is:
"When the cost type is "narrow", its range is 1 through 63; when the cost type
is wide, its range is 1 to 16777215."
Text Correction: "When the cost type is "narrow", its range is 0 through 63;
when the cost type is wide, its range is 0 to 16777215."
The Router 6000 Family uses the frame relay terminology Cir Allow and Cir,
instead of Cir and MinCir respectively. Please refer to the following documents:
'3Com Router Command Reference Manual' page 1033. '3Com Router
Configuration Guide' page 1019
Text Correction: Use CIR Allow when configuring the maximum Committed
Information Rate for the DTE when no network congestion exists. Use CIR as
the value to which the DTE will adjust when network congestion exists
Command manual example results in an error: "snmp-agent local-engineid
12345"
Text Correction: The command requires the user to enter a string of 5 to 32
octets of hexadecimal characters for the SNMP engine ID. Ex: 0102030405
The
command is non-existent in the Command Index.
virtualbaudrate
Use the "virtualbaudrate" command in the CLI.
[6080-3-Serial2/0/4]virtualbaudrate?
300
only for async mode
600
only for async mode
1200
for syn & asyn mode
2400
for syn & asyn mode
4800
for syn & asyn mode
9600
for syn & asyn mode
19200
for syn & asyn mode
38400
for syn & asyn mode
56000
only for syn mode
57600
for syn & asyn mode
64000
only for syn mode
72000
only for syn mode
115200
for syn & asyn mode
128000
only for syn mode
384000
only for syn mode
2048000
only for syn mode
ping -vpn -a xxx.xxx.xxx.xxx
MPLS
5
Advertisement
Table of Contents
