ResMed Swift FX Bella Gray User Manual page 23

Fitting
The Swift FX fitting illustrations in this user guide show the sequence
for obtaining the best fit and comfort when using your mask.
Fitting steps
1. Hold the pillows at your nose ensuring that the ResMed logo
is on the top of the pillows facing up. Pull the headgear over
your head. The headgear should sit midway between the ears
and eyes.
2. Adjust the top straps by pulling the strap through the buckle,
one notch at a time. Do not overtighten.
3. Adjust the side straps until a comfortable fit is achieved. The
back strap can be positioned over or under the hair.
4. Adjust the headgear until the nasal pillows sits comfortably in
your nose.
5. Check that the nasal pillows are positioned upright in the
entrance of your nostrils.
6. Finally, connect the free end of the short tube assembly to
the device air tubing.
The mask is now fitted and ready for use.
Removing your mask
To remove your mask loosen the upper strap, then pull the mask and
headgear up over your head.
Swift FX
6