ctrlX HMI DE0015, DE0021 Multi-Touch
Displays (Housing Devices)
Fig. 10-15: Removing the housing cover
10.3 Installation notes
When mounting the display, ensure an ergonomic operation. Additionally, en-
●
sure that all moving machine components can be seen by the operator at any
time
Avoid installation positions exposed to direct UV and sunlight. Direct sunlight
●
reduces the readability at the screen and causes additional warming
The LED display on the operator panel must not be covered.
●
Wire all cables in loops. Use strain reliefs for all cables
●
To maintain the degree of protection IP 65, use only a cable bushing of the
●
sealing gasket fitting to the cable cross sections. If required, use the fitting
sealing gasket
Do not lay the CDI cables in parallel to motor cables or to other noise sour-
●
ces, as the CDI connection can be disturbed. Keep the maximum distance
possible from interference sources
Mounting and electrical installation
R911405731_Edition 02 Bosch Rexroth AG
29/45