Installing The Recoil-Starter Rope In The Rope Guide; Filling The Engine With Oil - Toro Recycler 20357 Operator's Manual

1. Handle lock engaged
position
2. Set the handle lock
in place to lock the handle into the operating
position.
1. Handle lock
Note:
To adjust the handle height, refer to
the Handle Height (page
Figure 4
2. Handle lock disengaged
positions
(Figure 5) until the pin clicks
Figure 5
2. Pin
Adjusting
10).
2
Installing the Recoil-starter
Rope in the Rope Guide
No Parts Required
Procedure
Important:
To start the engine safely and easily
whenever you use the machine, install the
recoil-starter rope in the rope guide.
Hold the blade-control bar to the upper handle and
pull the recoil-starter rope through the rope guide on
the handle (Figure
g208181
1. Recoil-starter rope
3

Filling the Engine with Oil

No Parts Required
Procedure
Important:
Your machine does not come with oil
in the engine, but it does come with a bottle of oil.
Before starting the engine, fill the engine with oil.
g206253
Engine oil capacity: 0.5 L (16.9 fl oz)
Oil viscosity: SAE 30 or SAE 10W-30 detergent oil
API service classification: SJ or higher
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
6
6).
Figure 6
2. Rope guide
(Figure
g003251
7).