Table of Contents
Advertisement
Lamp replacement (Continued)
1
Unplug power cord.
2
Wait until lamp is sufficiently cooled.
Wait for at least 1 hour.
3
Remove the outer lamp cover.
Loosen the screw attached on the side of the outer
lamp cover. Remove the cover by sliding it in the
direction of the arrow.
4
Remove the inner lamp cover.
Remove the screws and carefully set them aside,
and remove the inner lamp cover. Be sure not to
loose the screws.
Pull out the lamp.
5
Loosen the lamp locking screws, pull up the
handle, and press the tab to remove the lamp.
6
Mount the new lamp.
Align the orientation, press down the new lamp until
the bottom is reached. Then lock it in place using
the lamp locking screws.
Outer lamp cover
Inner lamp cover
Tab
58
7
Replace the inner lamp cover.
Replace and tighten the screws removed in step
until the inner lamp cover is secure.
8
Replace the outer lamp cover.
Align the cover and slide in the direction of the arrow, then
tighten the screw loosened in step
3
until the outer lamp
cover is secure. Always replace the outer lamp cover.
9
Reset the lamp time.
See the lamp's manual for instructions on resetting
the lamp time.
Notes and Precautions
•
The [Lamp time] item in the Status display menu indicates the time of lamp use (Use it
as a rough estimate or guide for lamp life).
•
Please replace the lamp after 000 hours of use if [Lamp power] in the Default setting
1 menu is set to [Standard], or after 000 hours of use if [Lamp power] in the Default
p.40
setting 1 menu is set to [Low].
•
There may be cases where the lamp stops working before the above mentioned period
expires or before the replacement message is displayed.
•
Attach the outer lamp cover correctly so that it is secure and not loose. If it is not
attached correctly, the projector may fail to turn on or the lamp may fail to come on.
•
Always replace the lamp with a new one.
•
The lamp is made out of glass. Do not touch the glass surface with your bare hands,
bang it, or scratch it. Since dirt, jolts, scratches and the like could break the lamp.
About lamp replacement messages
•
The lamp replacement message of this projector displays an appropriate period
based on the use period selected in [Lamp power].
•
When the replacement time approaches, "The lamp life is ending. Please change
the lamp." message is displayed each time the power is turned on. The display
disappears when you press the
Used Lamps
This projector's lamp contains trace amounts of environmentally harmful inorganic
mercury. Be careful not to break used lamps, and dispose of them in accordance with
local regulations.
Inner lamp cover
4
Outer lamp cover
p.45
button.
59
Advertisement
Table of Contents
