Basic Setup (Vcr); Setting The Video Channel - Toshiba SD-V393SU Owner's Manual

Basic setup

Setting the video channel

When a TV is connected with the 75 ohm coaxial cable only.
To view playback of a recorded tape or DVD disc, or to watch a
program selected by the VCR's channel selector, the TV must be set to
channel 3 or 4 (video channel).
Setting the video channel
1
Press and hold 3 or 4 on the remote for 3
seconds in standby mode.
OR
2
Press POWER to turn on the DVD/VCR.
3
Press VCR DVD selector to select the VCR mode.
4
Turn ON the TV and set to CH 3 or 4 to corre-
spond with the channel selected in step 1.
5
Press TV/VCR to select the VCR position.
6 Select any channel to receive a TV station in your area.
The channel number will appear on the screen for
about 4 seconds.
22
2H20101A (E)p18-25
The video channel will
start to flash for 3
seconds in the display
window.
The VCR indicator on the
front panel will light.
The VCR indicator will
appear in the display
window.
22
For a push-button TV tuner
If CH 3 or 4 corresponding to the video channel cannot
be tuned on your TV, proceed as follows: set the VCR
3/4 channel selector and the TV to CH 3 or 4, play
back a prerecorded tape and tune the TV to receive a
sharp color picture from the video cassette recorder.
Refer to your TV owner's manual for details.
Note:
If the unit does not operate properly, or No key operation
(by the unit and/or the remote control): Static electricity, etc.,
may affect the player's operation. Disconnect the AC power cord
once, then connect it again.
2/10/05, 7:32 PM
POWER
VCR DVD
TV/VCR
3
4