Selecting The Signal Source; Programming Channels Into The Tv's Memory; Programming Channels Automatically - Toshiba 27AF42 Owner's Manual

Selecting the signal source

Use the TV/VIDEO button on the remote control or TV to select the
signal source connected to your TV.
To change the signal source:
Using the remote control: Press TV/VIDEO on the remote
control, and then press the corresponding CHANNEL NUMBER
for the desired source (see the illustration below).
Using the remote control or TV: Repeatedly press TV-VIDEO
until the selected signal source displays in purple.
0: TV
1: VIDEO 1
2: VIDEO 2
3: VIDEO 3
4: ColorStream
To verify the signal source:
Press RECALL or press TV/VIDEO on the remote control once.

Programming channels into the TV's memory

When you press CHANNEL
the TV stops only on the channels stored in the TV's memory.
Note: To tune the TV to a channel not programmed into the memory,
use the CHANNEL NUMBERS on the remote control.
Follow the steps below and on the next page to program channels into
the TV's memory.

Programming channels automatically

Your TV can automatically detect all active channels in your area
and store them in the TV's memory. After the channels are stored
automatically, you can manually add or erase individual channels
(see page 18).
To program channels automatically:
1. Press MENU.
2. Press or to highlight the SET UP menu.
x •
3. Press or to highlight TV/CABLE.
y z
4. Press or to highlight TV (if you use an antenna) or CABLE (if
x •
you use cable).
5. Press to highlight CH PROGRAM.
z
SET UP
LANGUAGE:
[ENGLISH] FRANCAIS ESPANOL
TV/CABLE: [TV] CABLE
CH PROGRAM
ADD/ERASE: [ADD] ERASE
MORE
SELECT [ ]
MOVE [ ]
6. Press or to start automatic channel programming ("CH
x •
PROGRAM" displays on-screen). The TV automatically cycles
through every TV or cable channel (depending on which you
selected), and stores all active channels in the TV's memory.
7. When automatic channel programming is complete, the message
"CH Programming Completed" appears.
8. Press CHANNEL ▲▼ to view the programmed channels.
▲▼ on the TV or remote control,
SET UP
LANGUAGE:
[ENGLISH] FRANCAIS ESPANOL
TV/CABLE: [TV] CABLE
CH PROGRAM
ADD/ERASE: [ADD] ERASE
MORE
[ ] SELECT [ ]
MOVE
17
TV Front Panel
DEMO MENU TV/VIDEO VOLUME
TV/VIDEO
CHANNEL z y
POWER
RECALL MUTE
o
1 2 3
4 5 6
7 8 9
CH RTN
100 0
ENT
CH
MENU/
VOL VOL
ENTER
CH
TV
CABLE
VCR
EXIT
FAV CH TV/VIDEO
A
REC TV/VCR STOP PLAY
STILL SOURCE PIP
SLOW PAUSE REW
FF
PIP CH LOCATE SWAP
CT-90037
CHANNEL
RECALL
CHANNEL
NUMBERS
MENU
yz x •
CHANNEL
yz
TV/VIDEO