Page 1
Connect your building’s coaxial cable to the HT-EM2’s Coax I/O port. POWER port, and plug it into a power socket. The MoCA LED turns on Blue when the HT-EM2 has discovered another MoCA device on the network. The POWER LED turns on Green when the HT-EM2 receives power.
Page 2
If you can see the website, your HT-EM2 is correctly set up! If no LEDs turn on, check the HT-EM2 is plugged in to the power source correctly. If the POWER LED turns on, but the LINK LED does not, wait up to 90 seconds. If the LINK LED remains off, contact your vendor. If the POWER and LINK LEDs turn on, but the MoCA LED does not, ensure that the HT-EM2 is correctly connected to the building’s coaxial cable network, that the...