Changing The Master And User Passwords In System Setup - Toshiba Tecra M3 Series User Manual

204
Keeping Your Files Safe
Hard disk drive passwords
2 Hold down the
button until the on/off light on the system indicator panel
illuminates (green) for approximately one second. When
the following message appears on the screen: "Check
system, Then press [F1] key," press
The System Setup screen appears.
3 Press
screen.
4 Press the spacebar to select Master + User password
mode.
5 Press an arrow key to move to the Master Password
section. You must register a Master Password first.
6 Press the spacebar, then type a password of 1 to 16
characters and press
of letters and numbers in your password.
7 When System Setup prompts you to verify the password,
type it again and press
If the two passwords match, System Setup displays:
for both User and Master passwords. If the two passwords do
not match, an error message appears. Repeat step 6 and step 7
to enter the password again.
8 Press
9 When System Setup prompts you to confirm your
change, press

Changing the master and user passwords in System Setup

To change the master and user passwords in System Setup:
1 Click Start, Shutdown, and then OK.
The computer shuts down.
2 Hold down the
button until the on/off light on the system indicator panel
illuminates (green) for approximately one second. When
key and press and hold the power
Esc
to move to the HDD PASSWORD section on the
H
to save the change.
End
.
Y
key and press and hold the power
Esc
. You may use any combination
Enter
.
Enter
.
F1
Registered