Directing The Display Output When You Turn On The Computer - Toshiba Tecra M2V Series User Manual

58
Connecting Other External Devices
Using external display devices
2 Connect the device's power cable to a live electrical
outlet.
3 Turn on the external device.
4 Set the display mode by pressing
Display Properties settings. For more information, see
"Directing the display output when you turn on the
computer"

Directing the display output when you turn on the computer

Once you've connected an external display device, you can
choose to use the internal display only, the external device
only, or both simultaneously. The quickest way to change the
display output settings is to use the display hot key (
1 Press
2 While holding down
setting you want takes effect.
This hot key cycles through the settings in the following
order:
3 Release the
below.
and simultaneously.
Fn F5
Built-in display only
Built-in display and external device simultaneously
External device only
key.
Fn
TECHNICAL NOTE: You can also change these settings using
the Display Properties Box.
Set the option for the video controller by clicking Start, then
Control Panel and clicking Display. Choose the Settings tab,
click the Advanced button, select Display Device, select the
applicable Monitor type, click Apply or OK.
Fn + F5
, press repeatedly until the
Fn F5
or by setting the
Fn + F5
):