Connecting To A Video Source - Epson EMP-73 Quick Reference Manual

Connecting to a Video Source

Turn off the power for both the projector and the video source before connecting them.
To video
white
output port
To audio
output port
* To output sound from the video equipment through the projector's built-in speaker, connect the video
equipment and the projector with the accessory A/V cable (white/red).
If connecting a component video source (such as a DVD player), you can use the optional
component video cable to connect the source to the Computer/Component Video port at the
Tip rear of the projector.
Preparation before Projecting
Power indicator
1 Remove the lens cover.
2 Insert the projector's power cable into
the projector.
3 Insert the power cable into an earthed
electrical outlet.
The Power indicator will light orange.
4 Turn on the power for the signal input
source.
For video equipment, press [Play] to start
playback.
5 Press to turn on the projector's
power.
The Power indicator will flash green, and
projection will then start (warm-up in
progress).
When connecting to a video
source with an S-Video
output port
To S-Video
output port
S-Video cable (commercially-available)
yellow
A/V cable
red
(accessory)
1
5
yellow
white
When connecting to a video
red
source with a video output port
2
If no images are projected, change the
input signal.
Tip
Projector
If connecting to a computer with a built-in
monitor, or to a laptop computer, you
may need to change the output
destination using the buttons or setting
menus.
User's Guide "Turning On the Power and
Projecting Images"
User's Guide
"Connecting to a Video Source"
S-Video port
Video port (yellow)
Audio 2 port
User's Guide
"Turning On the Projector"
3
Page down Page up
Computer S-Video/Video
Menu A/V Mute
E-Zoom
Remote control
Power
Color Mode
Freeze