Table of Contents
Advertisement
50
Getting Started
Adding memory (optional)
9
Carefully remove the new memory module from its antistatic
packaging, without touching its connector.
10
Locate an empty memory module slot on the underside of the
computer.
NOTE
NOTE
NOTE
11
Pick up the memory module by its sides, avoiding any contact
with its connector. Position the module toward the socket,
aligning the connector's notch with the matching key in the
socket.
notch
latch
key
(Sample Illustration) Aligning the memory module with the socket
Static electricity can damage the memory module. Before you handle
the module, touch a grounded metal surface to discharge any static
electricity you may have built up.
Avoid touching the connector on the memory module or on the
computer. Grease or dust on the connector may cause memory
access problems.
If no memory slot is available, you must remove a module by
performing steps
2-3
If your system has the memory modules stacked on top of one
another, you must remove the top module first before removing/
installing the bottom module.
For this model Slot A is the bottom slot. Slot B is the top slot. If only
one memory module is to be installed, it must be installed in slot A.
of
"Removing a memory module" on page
connector
latch
53.
Advertisement
Table of Contents
