Advertisement
Quick Links
ASE 549
ASE 573
ASE 550
ASE 574
ASE 551
ASE 575
ASE 552
ASE 576
ASE 553
ASE 577
ASE 554
ASE 578
ASE 555
ASE 579
ASE 556
ASE 580
ASE 557
ASE 581
ASE 558
ASE 582
ASE 559
ASE 583
ASE 560
ASE 584
ASE 561
ASE 585
ASE 562
ASE 586
ASE 563
ASE 587
ASE 564
ASE 588
ASE 565
ASE 589
ASE 566
ASE 590
ASE 567
ASE 591
ASE 568
ASE 592
ASE 569
ASE 593
ASE 570
ASE 594
ASE 571
ASE 595
ASE 572
ASE 596
USING THE BAIN MARIE UNITS AND HEATED GLASS TOPS
THESE APPLIANCES CONFORM TO THE FOLLOWING DIRECTIVES:
Ed: A
Data
Rev: Ø
01.01.2002
Rev: 1
30.06.2005
Rev: 2
Design Series ‐ Traditional Series 800 ‐ Traditional Series 700
BAIN-MARIE UNITS AND
HEATED GLASS TOPS
ASE 597
ASE 598
ASE 599
ASE 600
ASE 601
ASE 602
ASE 603
ASE 604
ASE 605
ASE 606
ASE 607
ASE 608
ASE 609
ASE 610
ASE 611
ASE 612
ASE 613
ASE 614
ASE 615
ASE 616
ASE 617
ASE 618
ASE 619
ASE 620
INSTRUCTIONS FOR INSTALLING AND
73/23 EEC: LOW VOLTAGE, ELECTRICAL SAFETY
89/336 EEC: ELECTROMAGNETIC COMPATIBILITY
93/68 EEC: EC MARKING REGULATIONS
Evento modifica
Prima emissione
Revisione Lay-Out
ASE 621
ASE 622
ASE 324
ASE 325
ASE 326
ASE 327
ASE 328
ASE 329
ASE 330
ASE 331
ASE 332
ASE 333
ASE 334
ASE 335
ASE 336
ASE 337
ASE 338
ASE 339
ASE 340
ASE 341
ASE 342
ASE 343
ASE 344
ASE 345
Redatto
Verificato
-
-
RSSC
ULGR
GB
ASE 346
ASE 031
ASE 347
ASE 032
ASE 348
ASE 033
ASE 349
ASE 034
ASE 350
ASE 035
ASE 351
ASE 036
ASE 352
ASE 037
ASE 353
ASE 038
ASE 354
ASE 039
ASE 355
ASE 040
ASE 356
ASE 041
ASE 357
ASE 042
ASE 358
ASE 043
ASE 359
ASE 044
ASE 360
ASE 045
ASE 022
ASE 046
ASE 023
ASE 047
ASE 024
ASE 048
ASE 025
ASE 049
ASE 026
ASE 027
ASE 028
ASE 029
ASE 030
Approvato
-
TNPL
Advertisement
Related Manuals for Whirlpool Design Series
Summary of Contents for Whirlpool Design Series
- Page 1 Design Series ‐ Traditional Series 800 ‐ Traditional Series 700 BAIN-MARIE UNITS AND HEATED GLASS TOPS ASE 549 ASE 573 ASE 597 ASE 621 ASE 346 ASE 031 ASE 550 ASE 574 ASE 598 ASE 622 ASE 347 ASE 032 ASE 551 ASE 575 ASE 599 ASE 324 ASE 348 ASE 033 ASE 552 ASE 576 ASE 600 ASE 325 ASE 349 ASE 034 ASE 553 ASE 577 ASE 601 ASE 326 ASE 350 ASE 035 ASE 554 ASE 578 ASE 602 ...
-
Page 2: Table Of Contents
SUMMARY 1. GENERAL WARNINGS pg.3 2. SPECIAL WARNINGS FOR POSITIONING AND WIRING THE APPLIANCE pg.3 3. POSITIONING pg.4 4. LEGAL PROVISIONS AND DIRECTIVES pg.4 5. ELECTRICAL AND EQUIPOTENTIAL WIRING pg.4 6. WATER CONNECTIONS pg.5 7. GENERAL OPERATING INSTRUCTIONS pg.5 8. CLEANING AND CARE pg.6 9. -
Page 3: General Warnings
1. GENERAL WARNINGS Only qualified installers and staff authorised by the manufacturer may perform the installation, start-up and maintenance work to the appliance. Read these instructions carefully beforehand, as they are very important for safety when installing, using and servicing the appliance. 1. -
Page 4: Positioning
3. POSITIONING Remove the protective film from the appliance. The appliance must be perfectly level, and any differences in floor level can be compensated by regulating the height of the feet. 4. LEGAL PROVISIONS AND DIRECTIVES The following provisions must be observed when connecting the appliance: 1. -
Page 5: Water Connections
6) WATER CONNECTIONS INLET: The pressure in the main water supply must be between 50 and 500 Kpa, in the event the pressure is higher, a pressure reducer must be installed upstream from the appliance. ¾” attachments are used. OUTLET: ¾”... -
Page 6: Cleaning And Care
8) CLEANING AND CARE Attention: direct water jets or pressurised jets must not be used to wash the appliance. Before using a new appliance, it must be carefully cleaned. Disconnect the appliance from the mains and clean it with hot water and normal detergent. Do not use acid or corrosive products, wire wool or brushes as these could deposit ferrous particles that would oxidise and cause rust. -
Page 7: 10. Use And Functions
10) USE AND FUNCTIONS 1. Open the water cut-off valve; 2. Turn on the appliance main switch; 3. Fill the bain-marie tank keeping the switch pressed until the water reaches the overflow mark (the tank empties by drawing off the overflow water); 4.