Toshiba M505D-S4930 User Manual page 207

The computer stops working (hangs) when you insert an
®
ExpressCard
The problem may be caused by an I/O (input/output) conflict
between the socket and another device in the system. Use Device
Manager to make sure each device has its own I/O base address.
See "Fixing a problem with Device Manager" on page 197
information.
Since all ExpressCards
required to have its own address.
Hot swapping (removing one ExpressCard
another without turning the computer off) fails.
Follow this procedure before you remove an ExpressCard
1 Click the Safely Remove Hardware icon in the Notification
Area.
The Safely Remove Hardware screen appears.
2 Click Safely remove for the device you want to swap.
3 Select the item you wish to remove and click OK.
4 Remove the device when told it is safe to do so.
Never swap modules when the computer is in Hibernation or Sleep
mode. This is known as "warm swapping" and is not supported. For
more information on Hibernation and Sleep modes see
mode" on page 86
The system does not recognize your ExpressCard
Refer to the ExpressCard
Removing a malfunctioning card and reinstalling it can correct
many problems.
An ExpressCard
Reinsert the card to make sure it is properly connected.
If the card is attached to an external device, check that the
connection is secure.
Refer to the card's documentation, which should contain a
troubleshooting section.
Resolving a hardware conflict
.
®
share the same socket, each card is not
and
®
documentation.
®
error occurs.
If Something Goes Wrong
"Sleep mode" on page
207
for more
®
and inserting
®
:
"Hibernation
87.
®
.