Table of Contents
Advertisement
68
Getting Started
Using the TouchPad™
❖
To move the cursor to the right side of the page, slide your
finger across the TouchPad from left to right.
❖
To move it to the left side, slide your finger from right to left.
NOTE
Once you have positioned your cursor, you can click it into place by
either double-tapping the TouchPad or clicking the control buttons.
Scrolling with the TouchPad
There are two active regions on the TouchPad
scroll as you would with any wheel device on a mouse or trackball.
To scroll vertically, run your finger up or down along the right edge
of the TouchPad. To scroll horizontally, run your finger along the
bottom edge of the TouchPad. This feature can be disabled or
changed in the Mouse Properties dialog box.
Control buttons
When a step instructs you to click or choose an item, move the
cursor to the item, then press and release the primary (left-hand)
button. To double-click, press the primary button twice in rapid
succession. The primary button usually corresponds to the left
mouse button.
The function of the secondary (right-hand) button depends on the
program you are using. It usually corresponds to the right mouse
button ("right-clicking"). Check your program's documentation to
determine whether it uses the right mouse button.
Disabling or enabling the TouchPad
The TouchPad
TouchPad setting, press
TouchPad. For more information, see
TouchPad™" on page
Because the TouchPad is much smaller than the display screen,
moving your cursor across the screen often means having to move
your finger several times across the TouchPad in the preferred
direction.
™
™
is enabled by default. To change the enable/disable
206.
™
+
. This hot key enables/disables the
Fn
F9
"Disabling or enabling the
™
that allow you to
Hide quick links:
Advertisement
Table of Contents
