Table of Contents
Advertisement
Mobile installation
The transceiver may be installed in any position in your car, where the
controls and microphone are easily accessible and it does not interfere with
the safe operation of the vehicle. If your vehicle is equipped with air bags,
be certain your transceiver will not interfere with their deployment. If you
are uncertain about where to mount the unit, contact your vehicle's dealer.
Prepare screwdriver to fasten and loosen screws.
1.
Install the mounting bracket in the vehicle using the supplied self-
tapping screws (4pcs) and flat washers (4pcs).
2.
Position the transceiver, then insert and tighten the supplied hexagon
SEMS screws.
Double check that all screws are tightened to prevent vehicle
vibration from loosening the bracket or transceiver.
Car body
Washer (M5)
Tapping screw
(M5x20mm)
Mounting bracket
Caution:
Use only the provided screws
otherwise you risk damaging
the circuit board, components
or fall-off of the unit.
Initial Installation
Determine the appropriate
angle of the transceiver, using
the 3 screw hole positions
on the side of the mounting
bracket.
3.
To remove the transceiver,
unscrew all fixing hardware,
and hold the transceiver
in the way that it won't fall
from bracket.
4.
I n s t a l l m i c h a n g e r u n i t .
Install the mic hanger in the
vehicle using the supplied
self tapping screws (2pcs)
and washers (2pcs).
2
2
Hide quick links:
Advertisement
Table of Contents
