Panasonic WX-SA250P Operating Instructions Manual page 18

Installation
3
Fix the (included) ceiling fixing bracket
A S lide the screws of the mounting unit installed in step 2 into the keyhole-shaped
holes of the fixing bracket to hold it in place.
B F ix the fixing bracket. Pay attention to the direction into which the arrow ( ) is
pointing relative to the fixing bracket. The arrow ( ) reflects where the top of the
antenna will point.
⿟ Screw torque: 0.39 N•m to 0.59 N•m {4 kgf•cm to 6 kgf•cm}
Fixing
bracket
(included)
Keyhole-shaped
holes (two) used for
Keyhole-shaped holes (two) used for
a Ø65 mm (2-9/16
a Ø120 mm (4-3/4 inches) aperture
inches) aperture on
on the ceiling
the ceiling
Important
⿟ Tighten the screws after sliding them past the protuberances in the
Important
two keyhole-shaped holes in the fixing bracket to keep the antenna
from accidentally falling. Not doing so may cause the antenna to fall.
⿟ Use a tool such as a torque screwdriver to tighten the screws to the
specified torque.
4
Connect the cable to the antenna
Route the LAN cable (page 16) through the fixing bracket and connect it to the
antenna.
See "Connections" (page 24) for details on connecting the cable.
LAN cable
18
Mind the direction
Temporary
attachment
Protuberance