Table of Contents
Advertisement
Land Pride
Section 5: Maintenance and Lubrication
Section 5: Maintenance and Lubrication
Maintenance
Proper servicing and adjustment is the key to the long life of
any implement. With careful and systematic inspection, you
can avoid costly maintenance, time and repair.
6. After using your seeder for several hours, check all
bolts to be sure they are tight.
7. After transporting your seeder for several hours,
check all bolts and nuts to be sure they are tight.
Storage
1. At the end of the working season or when your
Primary Seeder will not be used for a long period, it is
good practice to clean off any dirt or grease that may
have accumulated on the seeder and any of the
moving parts.
2. Be sure that the seed box is completely cleaned
before storing.
3. Place Rear Roller Pin in Parking position. (See Figure
2-2, page 15.)
Lubrication
Lubrication
Legend
4/03/08
Table of Contents
Multi-purpose
spray lube
20596
20585
4. The square bore of the seed cup drive sprocket hub
should be oiled to prevent seizing. Squirt oil on to the
square feed cup shaft and move seed cup adjustment
lever back and forth in order to get the oil back into the
square.
5. Lubricate all fittings as indicated.
6. When in storage, lower the seeder with rollers on a
board or hard surface and adjust the parking stand or
tongue jack.
7. Repaint parts where paint is worn or scratched to
prevent rust.
8. Replace all damaged or missing decals.
9. Store the seeder inside if possible. Inside storage will
reduce maintenance and make for a longer seeder
life.
10. Inspect the Primary Seeder for loose, damaged or
worn parts and adjust or replace if needed.
Multi-purpose
Multi-purpose
grease lube
oil lube
Drive Sprocket Hanger Bearing
(Small Grass Seeds Box)
Type of Lubrication: Multi-Purpose
Quantity = Coat sprocket bore thoroughly; move seed-rate
handle back and forth to get oil into sprocket bore.
IMPORTANT: DO NOT use petroleum lubricant on
the plastic seed cups. Petroleum will absorb into the
plastic and swell the plastic components.
Roller Bearings
Type of Lubrication: Multi-Purpose
Quantity = Coat Generously
PSN2096 Primary Seeders 313-306M
50
Intervals in hours at which
lubrication is required
hrs
25
Hours
25
Hours
25
Advertisement
Table of Contents
