Restoring A Back-Up Configuration; Dual Wl110 Wireless Pc Card Configuration - Compaq WL110 User Manual

11mbps wireless lan
Hide thumbs Also See for WL110:
Table of Contents

Advertisement

3. Follow the procedure as described in "Configuring other Access Points" on
page 8-17.

Restoring a Back-up Configuration

To restore previously saved back-up configuration files to your Access Point
proceed as follows:
1. Start the A PManager program.
2. Select the Access Point you want to upload the configuration file to.
3. From the Access Point menu select
4. Select the configuration file you want to upload, and click
5. When prompted to confirm the upload, verify whether the pop-up message
reflects the correct IP address.
When the IP address value is correct, click
Point will now reset automatically.
If the IP address in not correct, click
procedure
The new parameter settings will now be loaded into the FlashROM of the
Access Point. This means that the parameters will remain intact whenever the
Access Point is reset or switched off and on again. To change the parameters
again, simply repeat the procedure as described in this section to reconfigure
your Access Points.

Dual WL110 Wireless PC Card Configuration

Note: Only the WL510 Access Point has two PC Card slots. The WL410
Access Point has one integrated WL110 PC Card.
The use of two WL110 PC Cards in one WL510 Access Point can serve multiple
purposes, e.g.:
Migration between various generations of the 11Mbps Wireless LAN
products.
Doubling the capacity of the WL510 Access Point.
The dual slot design of the WL510 Access Point allows you to configure the
WL510 Access Point to operate with almost any combination of the wired and
wireless network interfaces listed above. This way your WL510 Access Point
provides easy migration paths between various generations of 11Mbps Wireless
LAN products.
A second WL110 PC Card inserted in the second slot of the Access Point will
double the capacity of the WL510 Access Point. This option might be used in
cases where a high rate of lost messages prevent fast data communication.
Note: Must have external antenna connected to at least one of the two PC
Cards in a dual configuration.
.
Upload Config File
to proceed. The Access
Yes
to return to cancel the upload
No
Advanced Network Configurations
.
Open
8-19

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Wl210Wl215Wl310Wl410

Table of Contents