Nesco ES-08 Manual

Handles
Glass Lid
How to assemble your electric skillet
Remove all parts from the packaging.
1. Locate and remove Lid Knob in packaging.
2. Place the screw through center hole of lid. The head of screw to inside of lid.
3. Place Protector Ring over screw threads on the outside of lid. Rough side of ring
facing glass.
4. Turn Lid Knob onto screw thread while pressing on head of screw.
5. Tighten screw until snug. Do not overtighten. The Lid is now ready for use.
Before using the appliance, READ AND SAVE ALL INSTRUCTIONS. Wipe down the
appliance with a soft damp cloth and make sure there is no metal or foreign objects
on the temperature control. Wipe dry with soft cloth.
1. Place appliance on a flat, heat resistant, stable surface in a well ventilated area.
2. Make sure the temperature controller is in OFF position. Insert control into inlet
on the side of skillet. Then insert plug into electrical outlet.
3. Adjust controller to desired setting. NOTE: The signal light on controller
indicates heat setting. When desired setting is reached, the light will turn off.
It will continue to cycle on and off during use to indicate heat setting is being
automatically maintained.
4. Preheat the skillet with the lid on for 10 minutes or until the indicator light goes out.
NOTE: The cooking temperatures listed in this user manual are estimates. Adjust the
cooking temperature slightly up or down to achieve the results you prefer.
5. A steam vent is located on the Glass Lid. The steam vent allows steam to escape
while cooking with the lid in place. CAUTION: Escaping steam is hot! Be careful
when removing or lifting lid. Oven mitts are recommended when removing cover
from skillet base or when replacing it.
Parts
Cooking Plate
Before first use
Operation
2
Lid Knob
Temperature
Controller