Hoop Calibration; Thread Away - Bernina Bernette b79 Workbook

Hoop Calibration

The Large, Medium and Small Hoops must be calibrated when they are new to the machine,
and also after every update. The calibration can be done with any of the three hoops, but
it needs only be done with one. You will only see the visual for the Medium Hoop regard-
less of the hoop being calibrated.
Calibration is essential because the variance of the basting box when selected to around the hoop perimeter is only a couple
millimeters away from the edge of the hoop.
For the most accuracy in calibration, have fabric hooped (with fabric and stabilizer) when calibrating a hoop.

Thread Away

The Thread Away feature causes a swift movement of the hoop after a thread has been cut that pulls the top thread up out
of the fabric and brings it out of the way so the top-side embroidery project will be perfectly clean with no thread to clip. This
feature is always active.
NOTE: Thread Away is always active and will engage anytime the thread is cut. Although the jump stitch length cannot be set
in the machine, the jump stitch length can be changed in Toolbox Embroidery Software. Set it very short (e.g. 3pts) if you wish
the thread to be cut between shorter jumps.
b e r n e t t e E M B R O I D E R Y M A C H I N E W O R K B O O K
1.
Use the fabric and stabilizer hooped in the Large Hoop
from Page 6.
2. Place the hoop's plastic template into the inner ring of the
hoop.
3. Attach the hoop to the machine. Refer to Page 7.
4. Touch the Setup Program icon.
5. Select the Embroidery Settings icon.
6.
Select Calibrate the Hoop icon. The machine will automat-
ically recognize the hoop that is attached.
7.
If the needle is not positioned exactly in the center of the
template, it must be centered using the arrow icons.
8.
Confirm with the green check box; the adjustment is
saved.
11