Table of Contents
Advertisement
SETUP
IMPORTANT: Remove and discard the protective
plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
IMPORTANT: To prevent accidental starting, do not
insert the electric-start button into the electric-start
ignition until you are ready to start the engine.
Note: The battery will arrive in 'sleep mode'. Refer to
Mower Maintenance - When to charge the Battery,
How to Charge the Battery for charging instructions.
Delivery Checklist
Check that the following items have been supplied
correctly.
1.
Engine Handbook
2.
Grassbag Assembly
3.
Parts List
4.
Declaration of Conformity
5.
Battery
6.
Battery Charger
If any items are missing, contact your local Hayter
dealer.
Fig. 1
Fig. 2
To prevent accidents cut off the long ribbon attached to
the grassbag and discard.
(Refer fi g.1)
Assembling and Unfolding the Handle
WARNING: Assembling and unfolding the handle
improperly can damage the cables, causing an unsafe
operating condition.
•
Do not damage the cables when assembling and
unfolding the handle.
•
Ensure that the cables are routed to the outside of
the handle.
•
If a cable is damaged, contact an Authorised
Service Dealer.
Unscrew the handle securing knobs suffi ciently to
allow the handle to pivot. Hold the engine stop lever
in towards the handle and unfold the handle to the
operating position, then release.
Tighten both handle knobs to secure in position.
(Refer fi g.2)
Grassbag Assembly
Before fi rst use assemble the grassbag and frame. Slide
Fig. 3
2
1
A
B
D
C
11
the frame (1) into the grassbag (2), ensuring that the
handle is above the grassbag as shown. Attach plastic
clips (A), (B), (C) and (D) to the grassbag frame.
Raise the rear defl ector, lower the grassbag and hook
into position. Lower the defl ector to rest on the
grassbag.
(Refer fi g.3)
Advertisement
Table of Contents
