Assembly - Baby Trend Navigator DJ86B Instruction Manual

ASSEMBLY

Remove stroller from box. The front wheel
and rear wheels be installed prior
MUST
to use.
FENDER
If assembly is necessary
(Fig. 1a), see Fender page 15.
FRONT WHEEL
To attach the front wheel, unfold stroller as
described in the section following:
• Unlock the release lever (Fig. 1a) and
1)
unfold stroller frame by pulling upward
on the stroller handle until the frame
locks (Fig. 1b).
• Slide the front wheel onto the front fork
2)
(Fig. 2).
• Slide the retainer plate onto the front
3)
wheel. Be sure that the raised lip is
pointing toward the fork and insert it
into the slot on the fork. The tab on the
retainer plate must be lined up with the
slot before tightening the wheel (Fig. 3).
• With the wheel in position, tighten the
4)
axel nuts and tighten with standard
crescent, box, or open end wrench.
You should feel significant resistance
and the wheel should be held tightly in
place (Fig. 4).
5
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 1a
Fig. 1b
Fig. 2
Front Fork
Slot
Axel and Hub
Retainer Plate
Axel Nut
Fig. 3
REAR WHEELS
• Rest the stroller upside down, on the
5)
handle.
• Press the rear wheel posts into the rear
frame hub until it clicks into place
(Fig. 5a).
NOTE: Pull on the rear wheel to ensure
that it is securely attached to the stroller.
• To remove the rear wheels, press the
wheel release button (Fig. 5b) on the rear
tube and pull the wheel from the hub.
TIRES
• Tires are shipped un-inflated. The tires
6)
should be inflated on a regular basis to
the P.S.I. specified on each tire. Always
use a bicycle style hand air pump to
inflate the tires. *Not included (Fig. 6).
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 4
Fig. 5a
Fig. 5b
Fig. 6
6