Advertisement

Help line: 0333 220 6050
TURBO POWER UPRIGHT VACUUM
Model: SC15830N
TURBO POWER PET
Model: SC15832N
TURBO POWER PET EXTEND
Model: SC15834N
v1.0
SC15830_32_34_IM.indd 1
14/01/2019 11:16

Advertisement

Table of Contents
loading

Summary of Contents for Swann Eureka TURBO POWER SC15830N

  • Page 1 Help line: 0333 220 6050 TURBO POWER UPRIGHT VACUUM Model: SC15830N TURBO POWER PET Model: SC15832N TURBO POWER PET EXTEND Model: SC15834N v1.0 SC15830_32_34_IM.indd 1 14/01/2019 11:16...
  • Page 2: Important Safeguards

    IMPORTANT SAFEGUARDS ! Follow caution information wherever you see this symbol. When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. WARNING This vacuum cleaner is intended for household use only and NOT for commercial or industrial use.
  • Page 3 IMPORTANT SAFEGUARDS • Always protect the power cable from heated surfaces and open flames. • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the vacuum cleaner in a safe way and understand the hazards involved.
  • Page 4 UNPACKING Carefully unpack and inspect your new Eureka | Swan vacuum cleaner for shipping damage. Each unit is tested and thoroughly inspected before shipping. For instructions regarding any shipping damage, call the Eureka | Swan Customer Service HELPLINE at 0333 220 6050 immediately. Make sure your vacuum cleaner is switched off and unplugged when cleaning, removing or refitting parts.
  • Page 5 PARTS 1. Handle 8. Wheel 2. Dust tank release 9. Connecting hose 3. Dust tank 10. 3-in-1 crevice tool accessory 4. Handle hose 11. Power cord 5. Power on/off 12. Power cord wrap 6. Nozzle 13. Turbo Pet Tool accessory SC15832N, SC15834N only 7.
  • Page 6 GET TO KNOW YOUR VACUUM WARNING: DO NOT plug in your vacuum cleaner until you have completely assembled it per the following instructions and are familiar with all instructions and operation procedures. Place the dust tank back onto Remove the dust tank before installing handle. the machine and push until Insert the handle into the vacuum body, then rotate the screw into body as shown.
  • Page 7: Operation

    Operation OPERATION Twist the quick release cord hook to Step on the brush cover and pull back on release the power cord. handle, to engage for operation. Plug in your machine and push ON/OFF To maintain optimal performance, please button to switch ON/OFF. emtpy dust tank when debris reaches MAX FILL line.
  • Page 8 Operation USING ACCESSORIES 3-in-1 Crevice Tool Accessory The 3-in-1 crevice tool with brush allows for vacuuming in narrow and hard-to-reach places. Turbo Pet Tool SC15832N, SC15834N models only For vacuuming pet hair from surfaces The handle hose c an be used immediately.
  • Page 9: Maintenance

    MAINTENANCE WARNING: Turn off and unplug vacuum cleaner before performing maintenance to the vacuum cleaner. Emptying and cleaning the dust tank Press dust tank release Hold dust tank over rubbish Close the base of the dust button to remove the dust bin and unclip the lock on the tank, align the tank base back tank.
  • Page 10: Cleaning Exhaust Filter

    MAINTENANCE WARNING: Turn off and unplug vacuum cleaner before performing - Cleaning Exhaust Filter maintenance to the vacuum cleaner. Locate and unlock filter cover as shown. Push left to un-lock, right to lock filter cover filter Remove filter cover with filter. Wipe with Wash with water every 3 months, cloth over rubbish bin, removing dirt and allow at least 24 hours to dry and...
  • Page 11 - Cleaning Dust Cup Filter MAINTENANCE 5. Hand wash the 6. Allow filter to dry 7. Twist filter assem- foam filter.. before putting back bly anti-clockwise to info vacuum cleaner remove for cleaning dirt and debris as needed. DO NOT operate without filter installed DO NOT wash dust tank in the dish washer DO NOT install filter if it is damp CAUTION:...
  • Page 12 MAINTENANCE Pet Tool (SC15832N, SC15834N only) UNLOCK LOCK 1. To release the pet tool 2. Pull up on the plastic upper 3. Remove plastic upper cap plastic upper cap for internal cap of the pet tool as shown. and clean, removing pet hair cleaning, roatate, unlock and and debris.
  • Page 13: Replacing The Drive Belt

    MAINTENANCE Remove Six Screws Replacing The Drive Belt Make sure the vacuum is switched off and unplugged first Check the drive belt carefully for wear, cuts and stressed areas. If the drive belt appears worn, you will need to replace it. To remove the drive belt, read the instructions and follow the drawings below: Grasp the old drive belt and remove from motor shaft.
  • Page 14: Troubleshooting

    MAINTENANCE Replace Brush Cover and i Screws TROUBLESHOOTING Vacuum cleaner won’t run Remedies Vacuum cleaner not plugged in 1. Check plug/socket Blown fuse/tripped breaker 2. Check fuse/breaker Vacuum won’t puck up dirt Remedies 1. Dust tank full 1. Empty dust tank 2.
  • Page 15: Technical Data

    DISPOSAL Appliances bearing the symbol shown here may not be disposed of in domestic rubbish. You are required to dispose of old electrical and electronic appliances like this separately. Please visit www.recycle-more.co.uk or www.recyclenow.co.uk for access to information about the recycling of electrical items. Please visit www.weeeireland.ie for access to information about the recycling of electrical items purchased in Ireland.
  • Page 16 SPARES www.eureka-swan.co.uk 1. SC15834N-01 3-in-1 tool WARNING: Turn off and unplug vacuum cleaner before performing - Cleaning Exhaust Filter tenance to the vacuum cleaner. 2. SC15834N-02 2 Metre Hose 3. SC15834N-03 Brush roll Locate and unlock filter cover as shown. 4.
  • Page 17: Warranty

    WARRANTY This product is guaranteed for 2 years from the date of original purchase. If any defect arises due to faulty materials of workmanship the faulty products must be returned to the place of purchase. Refunds or replacement is at the discretion of the store. The following conditions apply: •...
  • Page 18 NOTES SC15830_32_34_IM.indd 18 14/01/2019 11:16...
  • Page 19 NOTES SC15830_32_34_IM.indd 19 14/01/2019 11:16...
  • Page 20 www.eureka-swan.co.uk 2 year Est. 1 931 GUARANTEE Scan this QR code We love we’re proud Find us on Facebook to hear about what we do of our quality our story * on selected products Copyright © Swan Products Ltd. PO Box 3117, Stoke-on-Trent ST4 9GD SC15830_32_34_IM.indd 20 14/01/2019 11:16...

Table of Contents