Factory Reset - BIXOLON SRP-330II User Manual

5. Factory Reset

This function changes the WLAN settings of the printer to the initial factory settings.
Follow the instructions shown below to perform the Factory Reset.
1) Default Printer Settings
- Dynamic IP mode(DHCP mode is enabled.)
- Local Port: 9100
- Inactivity Time: 0
2) Procedure
(1) Turn the printer off.
(2) Turn the printer on while pressing the Function key.
[Note]
- Keep holding the Function key for about three seconds.
(3) Wait for about 10 seconds until IP address is assigned.
DHCP mode will be enabled when Factory Reset is performed regardless of the
existing settings.
[Note]
- Dynamic IP network environment
IP address is assigned to the printer and it can connect to web-server using the
assigned IP address.
Newly assigned IP address can be checked with the Function key.
- Fixed IP network environment
IP address is not automatically assigned to the printer.
Wait for 30 seconds and check whether IP address is assigned to the printer by
pressing the Function key. If IP address is 0.0.0.0, it means that IP address has
not been assigned. In this case, disable DHCP mode using the Configure Tool.
(4) Print the settings environment using the Function key.
Check the assigned IP address and connect to the web-server to change the settings.
3) Factory Reset Values
LAN Network
Rev. 1.00
Inactivity time
IP Assignment Method Automatic(DHCP)
- 9 -
Network Interface
0