Connection; About Speaker Grille; Specifications - JVC SX-WD10 Instructions Manual

Connection

Precautions
o
Before connecting:
• Turn off the power to the amplifier before connecting the speaker
system; otherwise, the speakers may be damaged.
• The impedance of the speaker is 6 K.
If this does not match with the speaker impedance range
indicated on the amplifier, you cannot connect this system to the
amplifier.
• The maximum power handling capacity of the SX-WD10 is 150
W. Excessive input will result in abnormal noise and possible
damage.
• Be sure to turn down the volume level on the amplifier to prevent
unwanted noise before performing following operations:
– Turning on or off other components
– Operating the amplifier
– Tuning FM stations
– Fast-forwarding a tape
– Continuously reproducing high frequency oscillation or high
pitch electronic sounds
– Connecting or disconnecting a microphone
• When using a microphone, do not aim it at the speakers or use
it near the speakers; otherwise, the howling which occurs may
damage the speakers.
• Before replacing the cartridge, always turn off the power both to
the amplifier and to the turntable; otherwise, the clicking noise
may damage the speakers.
Connecting the speaker system to the amplifier
o
• Twist and remove the insulation at the end of each
speaker cord before connecting.
G terminal
(Black hoop)
Silver
To the speaker F terminal of amplifier
To the speaker G terminal of amplifier
• Make sure to match the polarity (F and G); otherwise, the
surround effect will become less effective.

About Speaker Grille

To remove the speaker grille
o
To remove the speaker grille, insert your fingers at the bottom of
the speaker grille, then pull upward.
To attach the speaker grille, put the projections of the speaker
into the holes of the speaker grille.
• Do not press the speaker grille strongly.
Specifications
Type
Speaker unit
Mid and low range
Tweeter
Frequency range
Impedance
Crossover frequency : 3.8 kHz
Frequency range
Sound pressure level : 85 dB/W•m
Dimensions (WxHxD) : 270 mm x 1101 mm x 320 mm
Mass
F terminal
Supplied accessories : Speaker cord (3 m) (1)
(Red hoop)
Design and specifications subject to change without notice.
Copper
: 2-way 3-speaker bass-reflex type
Magnetically-shielded type
: 10.5 cm wooden cone x 2
: 2.0 cm wooden dome x 1
: 150 W
: 6 K
: 45 Hz to 50 000 Hz
g
: 16 k
Foot (3)
Base (1)
Screw (3)
4