Table of Contents
Advertisement
Drain Pipe and Drain Hose Installation
Care must be taken when installing the drain hose for the indoor unit to ensure that any condensation is correctly drained
outside. The drain hose can be installed to the left or right side of the base pan.
1. Install the drain hose as short as possible.
In order to discharge condensation water, the drain hose
should keep tilted.
NOTE
Secure the drain hose with the cable-tie not to be separated
from the unit.
The drain pump connection port is used when using a drain
pump.
2. When there is no draining pump, insulate the drain hose and then fix it
as a picture.
Insert the drain hose to bottom of the outfall of water basin.
Lock steel ring of the drain hose according to the figure.
NOTE
Wind and wrap steel ring and drain hose fully with thermal
insulation sponge; fix both ends of external layer with ribbon
for thermal insulation.
After being installed, drain hose must be insulated fully by heat
insulating material.(To be provided at site.)
3. While using draining pump, insulate the drain hose with heat insulating
material according to the figure.
Check if the rubber ring is installed properly on the draining
pump.
NOTE
Check if the drain cap blocks the outfall of drain pan properly.
ENGLISH-19
Metal clamp
Cable tie
Drain socket
Drain hose
Indoor
unit
Large sealing pad
Tighten the clamp to the maximum.
Drain piping
Advertisement
Table of Contents
