LG 3828A20229B Installation Manual page 14

WIRED REMOTE CONTROLLER INSTALLATION
• Since the room temperature sensor is in the remote controller, the remote controller box
should be installed in a place away from direct sunlight, high humidity and direct supply of cold
air to maintain proper space temperature.
Install the remote controller about 5ft(1.5m) above the floor in an area with good air circulation
at an average temperature.
Do not install the remote controller where it can be affected by:
- Drafts, or dead spots behind doors and in corners.
- Hot or cold air from ducts.
- Radiant heat from sun or appliances.
- Concealed pipes and chimneys.
- Uncontrolled areas such as an outside wall behind the remote controller.
- This remote controller is equipped with a seven segment LED. display. For proper display of
the remote controller LED's, the remote controller should be installed properly as shown in
Fig.5.
(The standard height is 1.2~1.5 m from floor level.)
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13 15 17 19 21 23
no
N
TIO
B FU NC t
SU Pre ify hea
D ate r mid r
EE He t Hu t doo
N SP AUT O fros De Ou 4
FA JET er Filt 3
MP HI 2
T TE p MED 1
SE m Tem LO 23
N Roo NE
IO ZO 21
ER AT 19
OP e 17
ING Ti m
SW m set 15
TO gra 13
AU Pro 11
09
t 07
tion uni
Op era 05
03
m er f 01
Ti Tim Of e
On no.
Set
no
Figure 5 Typical locations for remote controller
yes
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13 15 17 19 21 23
no
5feet
(1.5meters)
Installation of Unit
Installation Manual 13