Table of Contents
Advertisement
Wired LAN Related
Q1 <Wake On LAN> function
A1
<Wake On LAN> is a function that activates the system in rest mode when a sig-
nal (such as ping or magic packet commands) arrives from network (wired LAN).
To use <Wake On LAN> function:
z
Select My Network Places > View network connections from the Desktop.
x
Click the right button on the touchpad over Local Area Connection, and select
Properties.
c
Click Configure, and select Power Management tab. Select 'Allow this device
to bring the computer out of standby', then click OK. Restart the system.
- When turning the computer off when the network is connected without selecting
the <Wake On LAN> function, the LAN LED may not be turned off.
- The <Wake On LAN> function is only available when the LAN is turned on.
- When connecting a wired LAN while using a wireless LAN, the <Wake On
LAN> function may not work. To use the <Wake On LAN> function, select 'Do
not use Wireless LAN'.
- Connecting wired LAN while using wireless LAN may not execute <Wake On LAN>
function. Configure wireless LAN to 'Disable' to use <Wake On LAN> function.
z
Click on My Network Place> View network connections on the Desktop.
x
Right-click over Wireless Network Connection and select Disable.
A2
The <Wake On LAN> function is configured so that it is supported in Standby
Mode (S3).
To use this function in Hibernation Mode (S4) or in the Turn Off (S5) state, con-
figure it as follows:
z
Enter the BIOS SETUP and select the Boot menu.
x
Move to the Wake On Lan item and press the Enter key. Change it from Dis-
abled to Enabled and press the Enter key.
Q2 When I connected 100Mbps wired LAN and the computer exits standby/hi-
bernate mode, a message informing 10Mbps wired LAN connection appears.
A
When the computer exits standby/hibernate mode, restoring the network takes
about 3 seconds. When the network is restored, it operates in 100Mbps.
124 Users Manual
Advertisement
Table of Contents
