Connecting The Fm And Am(Mw/Lw) Antennas; Connecting The Video To Tv - Samsung HT-EV100 Instruction Manual

Connecting the FM and AM
1 2 3
AM Loop Antenna
(supplied)
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.
AM
SPEAKERS (6 )
ANTENNA CENTER
FM
75
COAXIAL
FRONT WOOFER REAR
FM antenna connection
1. Connect the FM antenna supplied to the FM 75
COAXIAL terminal as a temporary measure.
2. Slowly move the antenna wire around until you
find a location where reception is good, then
fasten it to a wall or other rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75 coaxial cable (with a standard
type connector), disconnect the supplied FM antenna.
The cooling fan dissipates the heat generated inside the unit so that the unit can be operated
Cooling Fan
normally. The cooling fan is activated automatically to supply cool air to the unit.
Please observe the following cautions for your safety.
AM
•
Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise
SPEAKERS (6 )
ANTENNA CENTER
FM
75 and may damage it.
COAXIAL
FRONT WOOFER REA
• Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a
newspaper or cloth, heat may build up inside the unit and fire may result.)
13
Antennas
( MW/LW )
If AM reception is poor, connect an
outdoor AM antenna(not supplied).
If FM reception is poor,
connect an outdoor FM
antenna (not supplied).
AM
ANTENNA
FM
75
COAXIAL
FM Antenna (supplied)
DIGITAL IN VIDEO OUT
OPTICAL
AUX IN
L
R
AM antenna connection
(MW/LW)
1. Connect the AM loop antenna supplied
to the AM and terminals.
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM ter-
minal. (Keep the AM loop antenna con-
nected).

Connecting the Video to TV

AM
SPEAKERS (6 )
ANTENNA CENTER
FM
75
COAXIAL
FRONT WOOFER REAR
TV
Composite Video (Good Quality)
Connect the supplied video cable from the VIDEO OUT jack on the back panel of the
system to the VIDEO IN jack on your television.
Scart (Best Quality)
If you television is equipped with an SCART input, connect an Scart Jack (not supplied)
from the AV OUT jack on the back panel of the system to the SCART IN jack on your
television.
For using the SCART cable
• If Scart is equipped for your TV, set RGB-COMPOSITE selector
of the center unit to RGB. You can get a better picture quality by
using Scart setting.
• If Scart (RGB Input) is not equipped for your TV, set RGB-
COMPOSITE selector to COMPOSITE.
•
On the rear panel SCART cable is indicated as "AV OUT."
Note
DIGITAL IN VIDEO OUT
OPTICAL
AUX IN
L
R
SCART VIDEO
IN IN
14