Samsung HT-DB390 Instruction Manual page 15

Resetting Wireless Communication
Reset the system if a communication failure occurs or if the synchronizing signal indicator does not light up
and the "REAR CHK" message blinks on the main unit's display because the wireless rear amplifier is not
recognized. Reset the system while the main unit and the wireless rear amplifier (SWA-1000) are in Power
Standby mode.
1
With the main unit turned off, press and
hold the remote control's WIRELESS for
4 seconds.
•
Press the button until the volume control indicator
lights up blue. (The indicator will turn off in 1 second.)
2
With the wireless rear amplifier turned
on, use a ball point pen or a pair of
tweezers to press the RESET button
on the back of the unit 2 to 3 times.
3
Turn on the main unit.
•
The wireless rear amplifier's synchronizing signal
indicator will light up.
•
If Power Standby mode continues, repeat Steps 1
to 3 above.
Turning On the Mood Light
You can turn on or off the mood light on the wireless rear amplifier as well as change the color of the light to one of
the 7 different colors according to your preference or your room atmosphere.
1
Press the POWER button.
•
The Power Standby indicator on the
front panel will light up and the
mood light will turn on.
Turning Off the Mood Light
•
In Power Standby mode, press the ON/OFF button.
Only the mood light can be turned on or off. The mood light will light up or turn off with the
last color selected.
•
Press the POWER button.
The wireless rear amplifier and the mood light will turn off.
If the POWER button is pressed again, the mood light will always light up blue.
Back of Wireless Rear Amplifier
Caution
•
Sound will be heard from the wireless rear speakers in
DVD 5.1-CH or Dolby Pro Logic II mode only.
•
In 2-CH mode, no sound will be heard from the wireless
rear speakers.
2
Press the COLOR MODE button.
•
Each time the button is pressed, the color changes as
follows: Blue Light Green
Yellow Pink
RESET Button
Red Sky Blue
White.
14