Selecting The Location; Connecting Power; Operation; Change Unit Of Measure - U-Line OHAUS SCOUT H-5848 Manual

Table of Contents

Advertisement

Available languages

Available languages

SELECTING THE LOCATION

1.
For best performance, the balance should be used
in a clean, stable environment.
2. Do not use the balance in environments with
excessive drafts, with rapid temperature changes,
near magnetic fields or near equipment that
generates magnetic fields or vibrations.
LEVELING
1. The scale has an illuminated
level indicator as a reminder
that the balance should be
leveled for accurate weighing.
There is a level bubble in a small
round window on the front of the
balance. To level the balance,
adjust the feet at each corner
until the bubble is centered in
the circle. (See Figure 4)
2. Be sure the balance is level each
time its location is changed.

CONNECTING POWER

AC ADAPTER
1. AC power is used to power the scale when battery
power is not needed.
2. Connect AC adapter (supplied) to the AC adapter
input jack at the rear of the balance. Then, connect
the AC plug to an electrical outlet. (See Figure 5)
Interface
AC Adapter
Connection
Input Jack
TURNING THE BALANCE ON / OFF
1. To turn the balance on, press and hold the
ZERO button for one second. The balance performs
a display test, momentarily displays the software
version and then enters the active weighing mode.
2. To turn the balance off, press and hold the
OFF
ZERO button until
PAGE 3 OF 33
SETUP CONTINUED
Figure 4
Yes
Figure 5
Security Slot
(Anti-Theft Lock Slot)
is displayed.
BATTERY
1.
Install four AA batteries with polarity as shown in the
battery compartment. (See Figure 6)
Weigh
Below Hole
Security
Switch
No
Battery
Compartment
Cover
SECURITY SLOT
1. A security slot is provided at the rear of the balance,
allowing the balance to be secured by an optional
cable and lock accessory. (See Figure 5)

OPERATION

CHANGE UNIT OF MEASURE

1.
Press and hold the PRINT/UNITS button until the
desired weighing unit appears.
NOTE: Units of measure must be enabled. To
enable units of measure, see Unit Menu under
Menu Settings on page 10.
Figure 6
0218 IH-5848

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents