Performing The Sequential/Self-Timer Shooting - Olympus E-M10 Mark III S Instruction Manual

Performing the sequential/self-timer shooting

Adjust settings for burst or self-timer photography. Choose an option according to your
subject.
Press the jY (G) button.
1
Highlight one of the following options using HI.
2
2
o/
o/
Single
♥o
T/
Sequential
♥T
High
S/
S/
Sequential Low
♥S
Y12s/
Y 12 sec
Y12s/
♥Y12s
Y2s/
Y 2 sec
Y2s/
♥Y2s
YC/
Custom Self-
YC/
timer
♥YC
Items marked with  reduce the slight blur caused by the movement of the shutter.
Items marked with ♥ use the electronic shutter. Use these with shutter speeds faster than
1/4000 seconds, or in settings where the sound of the shutter would be unwelcome.
Press the Q button.
3
• Fix the camera securely on a tripod for self-timer shooting.
• If you stand in front of the camera to press the shutter button when using the self-timer,
the picture may be out of focus.
• When you are using S, S or ♥S, live view is displayed. In T or ♥T, the display
shows the last photograph taken during the sequential shooting.
• The speed of sequential shooting varies depending on the lens you are using and the
focus of the zoom lens.
• During sequential shooting, if the battery level icon blinks due to low battery, the camera
stops shooting and starts saving the pictures you have taken on the card. The camera
may not save all of the pictures depending on how much battery power remains.
$
• To cancel the activated self-timer, press G.
68 EN
1 frame is taken at a time when the shutter button is pressed.
With T, pictures are taken at up to about 8.5 frames per
second (fps) while the shutter button is pressed all the way
down. With ♥T, pictures are taken at up to about 14 fps.
Focus, exposure, and white balance are fixed at the values for
the first shot in each series.
Pictures are taken at up to about 4.8 frames per second (fps)
while the shutter button is pressed all the way down. Focus
and exposure are fixed according to the options selected for
[KAF Mode] (P. 75) and [AEL/AFL] (P. 120).
Press the shutter button halfway to focus, the rest of the way
down to start the timer. First, the self-timer lamp lights up for
approximately 10 seconds, then it blinks for approximately
2 seconds and the picture is taken.
Press the shutter button halfway to focus, the rest of the
way down to start the timer. The self-timer lamp blinks for
approximately 2 seconds, and then the picture is taken.
Press the INFO button to set [Y Timer], [Number of Frames],
and [Interval Length].
Use HI to highlight items and FG to choose a value.