Charge The Batteries - Fluke FiberInspector Micro User Manual

Charge the Batteries

To avoid possible fire, electric shock, personal injury, damage to the
video microscope, or incorrect operation:

Use only the ac adapter/charger provided to power the display and
charge the batteries.

Disconnect the battery charger and move the Product or batteries
to a cool, non-flammable location if the rechargeable batteries
become hot (>50 °C, >122 °F) during the charge period.

Do not recharge non-rechargeable batteries.

Batteries contain hazardous chemicals that can cause burns or
explode. If exposure to chemicals occurs, clean with water and get
medical aid.

Repair the Product before use if the battery leaks.

Do not keep cells or batteries in a container where the terminals
can be shorted.

Do not put battery cells and battery packs near heat or fire. Do not
put in sunlight.
When the battery charges, the LED is red. Charge the batteries
for about 4 hours before you use them for the first time.
The charger is connected and no batteries are installed.
When the battery is fully-charged, the LED is green. Fully-
charged batteries last about 3 hours when the display is on
continuously.
When the battery is very low, the battery icon shows a red bar.
The LED blinks red and green and the yellow battery icon shows
if you connect the power adapter when the wrong type of
batteries are installed. See the specifications for the correct
battery types.
The microscope will operate with alkaline batteries, but they will
drain quickly. The display will not try to charge alkaline batteries.
W X
Warning
7