AA68-03437A-00Eng_UMG_TM75
ENG
Rear of the TV
P 4
5/7/04
4:25 PM
Inserting the Batteries in the Remote Control
You must insert or replace the batteries in the remote control when
you:
Connecting to an Aerial or Cable Television Network
To view television channels correctly, a signal must be received by
the set from one of the following sources:
or
Cable Television
Network
Mono
10
Page 10
N Purchase the television
N Find that the remote control is no longer operating
correctly
1
Remove the cover on the rear of the remote control by pressing
the symbol
downwards and then pulling firmly to remove it.
(
)
2
Insert two R03, UM4, "AAA" 1.5V or equivalent batteries taking
care to respect the polarities:
N
- on the battery against - on the remote control
N
+ on the battery against + on the remote control
3
Replace the cover by aligning it with the base of the remote
control and pressing it back into place.
N An outdoor aerial
N A cable television network
N A satellite network
1
In the first three cases, connect the aerial or network input cable to
the 75Ω coaxial socket on the rear of the television.
2
If you are using an indoor aerial, you may need to turn it when
tuning your television until you obtain a picture that is both sharp
and clear.
For further details, refer to:
N
"Storing Channels Automatically" on page 15.
N
"Storing Channels Manually" on page 16.
➢
Signal Strength(
The "
"(Signal Strength) symbol is displayed by
pressing the "INFO (
signal strength for your watching TV channel. The more
signal bar is the better TV gets sensitivity on current
channel.
) display (Option)
)" button. This symbol displays