Before Fitting The Turntable; Fitting The Turntable; Fitting The Slipmat; Attaching The Balance Weight - Technics Red Bull BC One SL-1200MK7R Owner's Manual

Before fitting the turntable

1
Remove the magnet cover from
the turntable.
 There is a magnet and its cover on the
back side of the turntable.
Remove the magnet cover before fitting
to the main unit.
Back side of the turntable
Magnet
Attention
 Keep any magnetic-sensitive object such as
a magnetic card and watch away from the
magnet.
 Prevent the turntable from hitting the main
unit or falling off.
Prevent dust or iron powder from adhering
to the magnet on the back side.
 Do not touch the fixing screws (three
locations) of the turntable. The rating
performance cannot be guaranteed if they
are out of position.

Fitting the turntable

2
Slowly set the turntable on the
center spindle.
Attention
 Be careful when handling the turntable, as it
is heavy.
 Keep your fingers from being caught.
 Wipe off fingerprints or dirt with a soft cloth.
Magnet cover
Fixing
screw

Fitting the slipmat

3
Lay the slipmat and slip sheet on
the turntable.
 A record on the rotating turntable can
be stopped manually as well as rotated
in reverse.
 Laying a slip sheet on the turntable
changes the slip-cueing feel.
Attention
 When performing scratching (including reverse
play), use a cartridge and stylus for DJs.

Attaching the balance weight

4
Attach the balance weight to the
rear of the tone arm.
Balance weight
Note
 The inside of the balance weight is greased.

To remove the turntable

As shown in
the figure on
the right, set
your fingers in
the two holes
on the turntable,
hold the center spindle down and
remove the turntable upward.
Slipmat
Slip sheet
11
(11)
English