Page 1
O M N I - D I R E C T I O N A L D I G I T A L A N T E N N A CA-1000WIFI INSTALLATION INSTRUCTION GUIDE FOR NEW INSTALL OR UPGRADE KIT 5935 W.
Page 2
It is the responsibility of the installer to ensure that this mount is installed safely. W F R U T A H W F N W -F -25° 145° O CA-1000WIFI 2 (T ) TV HD A CA-1000WI- FI W Frequency Range...
Page 3
The long sides will run from the front of the vehicle to the back. With the Dipole’s directed towards the back. Before installing CA-1000WIFI, it is recommended that you check with your vehicle manufacturer for any special screw or installation requirements. Follow the assembly diagram below (FIG 3.) to install your CA-1000WIFI.
Page 4
With the CA-1000WIFI upgrade kit, the baseplate will come pre-installed on the RV. Note: The CA-1000WIFI uses the same baseplate as the CA-1000 antenna that is installed by the factory. If your RV does not have a CA-1000 antenna, please refer to the instructions on page 2 for installing a new CA-1000WIFI antenna baseplate.
Page 5
Connect the appropriate cables and wires, and tape all the coax connections. The CA-1000WIFI has 3 wires you will need to connect to the CWP-2000B Wall Plate. (FIG 5.) Coaxial Cable: This cable sends TV signal to your TVs inside the RV.