Troubleshooting Guide - The Singing Machine iSM1080 Instruction Manual

Troubleshooting Guide

Should this unit exhibit a problem, check the following before seeking service:
No Power
• Power is not on; press the
• Confirm that the AC adapter is connected securely to the rear of the unit.
• Connect the unit to a different outlet.
• The normal function of the product may be disturbed by strong Electro-Magnetic
Interference. If so, simply restart the product to resume normal operation by following
the instruction manual. In case the function could not resume, please use the product in
another location.
No Sound – General
• Music Volume is set to minimum; raise volume.
• If using an external device, raise the volume.
No sound from the microphone
• Make sure the microphone is firmly connected to the MIC 1 or MIC 2 jack.
• Make sure the mic's ON/OFF switch is set to the ON position.
MIC VOLUME/ECHO
• Make sure the
File(s) on USB jack not playing
• The file is corrupted; replace the file.
• The file is not in a format this unit will play.
• The connected USB device is not supported by the product.
The Bluetooth device cannot be paired or connected with the unit
• Ensure any other Bluetooth devices are turned off to avoid accidental pairing.
• You have not activated the Bluetooth function of your device; see page E16 or refer to
the Bluetooth device user's manual.
• The system is not in pairing mode; press and hold the
The Music is not available on the unit after successfully connecting the Bluetooth
• Ensure your Bluetooth device can support the A2DP Bluetooth profile.
• The volume on the external Bluetooth device is set too low or muted; raise as desired.
The unit will not record
• No USB drive inserted or the USB drive is full. Move all recordings to your computer to
make room.
Failed to connect to the Wifi network
• The unit is not within the WiFi signal range.
• Check that your WiFi frequency is 2.4GHz.
• Ensure you have entered the correct password.
ON/STANDBY button to turn power on.
control is not set too low.
— E25 —
button to restart pairing.