Neles Jamesbury Series Installation Maintenance And Operating Instructions

Neles Jamesbury Series Installation Maintenance And Operating Instructions

Advertisement

Adding live-loaded packing
option to Jamesbury™
Wafer-Sphere™ high
performance butterfly valve
Installation, maintenance and
operating instructions
IMO-317 EN
Issue 10/2020

Advertisement

Table of Contents
loading

Summary of Contents for Neles Jamesbury Series

  • Page 1 Adding live-loaded packing option to Jamesbury™ Wafer-Sphere™ high performance butterfly valve Installation, maintenance and operating instructions IMO-317 EN Issue 10/2020...
  • Page 2: Table Of Contents

    Table of contents GENERAL Scope of the Manual Valve Markings Safety Precautions INTRODUCTION LIVE-LOADING INSTALLATION MAINTENANCE PRODUCT ORDERING INFORMATION REPAIR KITS/ SPARE PARTS READ THESE INSTRUCTIONS FIRST! SAVE THESE INSTRUCTIONS! These instructions provide information about safe handling and Addresses and phone numbers are printed on the back cover. operation of the valve.
  • Page 3: General

    Size OUTSIDE THE SCOPE OF THIS MANUAL. IF YOU HAVE ANY QUESTIONS CONCERNING THE Valve catalog code USE, APPLICATION OR COMPATIBILITY OF THE VALVE Model WITH THE INTENDED SERVICE, CONTACT NELES FOR MORE INFORMATION. Pressure Body Material WARNING: Seat Material...
  • Page 4: Introduction

    Please pay close attention to the following instructions when installing WARNING: live-loaded packing conversion kits in your valves. BEWARE OF THE DISC MOVEMENT! Valve shown in KEEP HANDS, OTHER PARTS OF THE BODY, TOOLS Open Position AND OTHER OBJECTS OUT OF THE OPEN FLOW PORT.
  • Page 5: Maintenance

    IMO-322 Series 860 (3”-12”) Model C Individual parts from the live-loaded conversion kit parts can also be ordered through your Neles authorized Distributor or Install new compression ring (5) (shorter than the one representative. just removed), and replace the retainer ring (47) and the compression plate (10).
  • Page 6 Subsequent Springs to be stacked in series as shown, quantities vary depending on kit #. To obtain proper load, (See Note 2 under Table 1.) tighten down on nut until top of at washer is even with top of housing. Body Stud (See Item 7 under LIVE-LOADED...
  • Page 7 IMO-317 EN - Issue 10/2020...
  • Page 8 Tel. +358 10 417 5000. neles.com Subject to change without prior notice. Neles, Jamesbury and Easyflow by Neles, and certain other trademarks, are either registered trademarks or trademarks of Neles Corporation or its subsidiaries or affiliates in the United States and/or in other countries. For more information www.neles.com/trademarks...

This manual is also suitable for:

Jamesbury 815Jamesbury f815Jamesbury 818Jamesbury f818Jamesbury 830Jamesbury f830 ... Show all

Table of Contents