4- Target Depth Measurement - Cobra GX 8000 Manual

7.1.4. Target Depth Measurement
[ ] 1
The user must cross the flat lines on the ground to form a specific area.
[ ] 2
As a result of the intersection of the area diameters, the center of the
area is determined to the user.
[ ] 3
The user starts to measure the depth from the area center straight
to one of the diameters of this area.
[ ] 4
The user does not have to track the antenna movement in this case but
adheres to the straight movement.
[ ] 5
After reaching a certain distance, the antennas will go oppositely. At this
point the user will mark a line on the ground and the distance between
this line and the center of the area will be the depth of the target.
[ ] 6
It is recommended for the user to measure the depth from two different
diameters for accuracy.
Notice
The distance traveled along the diameter direction is same as the target's depth
Example: If the distance is between the center and the antenna intersection point
3 meters, this shows that the target depth is also 3 meters.
3m
TARGET
18