Table of Contents
Advertisement
15 ARCHIVE
15.1 How to initiate, restart and stop recording
To start, resume or stop archiving, select the
In the left bottom corner of the screen, there is a button which, depending on the current
archiving status may start the archiving
To create a new archive in first step stop the archiving process, and then press
the button
archivization.
!
Turning off the power could cause the loss of a few last records
(approx. 1 Minutes).
15.2 Archive settings
The archive settings are available in
Archive files: Daily ( Daily, Weekly, Monthly)
MAIN ARCHIVE interval
I: 2s (2s, 5s, 10s, 15s, 30s, 1min, 5min, 10min, 15min, 30min, 1h, 2h, 4h, 12h, 24h)
II: 2s (2s, 5s, 10s, 15s, 30s, 1min, 5min, 10min, 15min, 30min, 1h, 2h, 4h, 12h, 24h)
TOTALIZERS ARCHIVE interval: 1min (1min, 5min, 10min, 15min, 30min, 1h, 2h, 4h, 12h,
[4]
24h)
[1]: The archiving files are created in the daily, weekly and monthly system.
[2]:
The basic MAIN ARCHIVE interval (I). Recording interval should correspond to the
measurement process. If the recording interval is too short, the large data volumes will
make it difficult to analyse the results. If the recording interval is too long, rapid
changes in the measured values cannot be identified.
[3]:
The second MAIN ARCHIVE interval (II) is used when the recording is controlled by
exceeded alarm/control thresholds (see Section Alarm).
[4]:
The frequency with which the totalizers data are saved in the archive.
15.3 Archive field types
The archive files were divided into 3 types:
Data archive (YYADXX.csv)
Totaliser archive (YYATXX.csv)
Event archive (YYAEXX.csv)
. After creating a new archive file, it is necessary to restart the
icon from the side menu.
or stop it
→
[1]
61
DL7, DL7L
.
[2]
[3]
Advertisement
Table of Contents
