Regency Fusion MFTT Series Instructions

MFTT####, MTT####, MSP####, MDP#### - INSTRUCTIONS
Organize your parts and hardware. You will need (2) people, a Phillips head screwdriver and a rubber mallet.
Parts:
A) Top Bracket(2) ● B) Foot Bracket(2) ● C) Back Support(2) ● D) Front Support(2) ● E) Exterior Leg Cover(2) ● F) Interior Leg
Cover(2) ● G) Wire Management Trough (ITEM MTT### ONLY) ● H) Modesty ● I) Table Top
NOTE: Back Supports differ from Front Supports with additional holes for modesty attachment.
B
A
H
Hardware:
J) Screws(6) ● K) Washers(4) ● L) Bolts(12) ● M) Glides(4)
J
STEP 1: Insert 2 Glides(M) into each of the Foot Brackets(B).
IMPORTANT NOTICE:
● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
● Check to be sure that you have all parts and hardware.
● Remove all wrapping materials, including staples & packing straps before you start to assemble.
● Do not tighten all screws/bolts until completely assembled.
● Keep all hardware parts out of reach of children.
C
D
K L
M
Any problems or questions call Regency Office Furniture at 1-866-816-9822
F
E
I
M
B
M
G