Download Print this page
Nederman MagnaTrack Instruction Manual
Nederman MagnaTrack Instruction Manual

Nederman MagnaTrack Instruction Manual

Fan start/stop device program kit d2-3
Hide thumbs Also See for MagnaTrack:

Advertisement

Quick Links

Instruction manual
Control Equipment
Fan Start/Stop Device
Program Kit D2-3
Original instruction manual
EN
INSTRUCTION MANUAL
2014-04-04
144936(00)

Advertisement

loading

Summary of Contents for Nederman MagnaTrack

  • Page 1 Instruction manual Control Equipment Fan Start/Stop Device Program Kit D2-3 Original instruction manual INSTRUCTION MANUAL 2014-04-04 144936(00)
  • Page 2 Fan Start/Stop Device Program Kit D2-3 Figures ..............................English ..............................
  • Page 3 Fan Start/Stop Device Program Kit D2-3 Figures...
  • Page 4 Fan Start/Stop Device Program Kit D2-3...
  • Page 5 Fan Start/Stop Device Program Kit D2-3...
  • Page 6 Fan Start/Stop Device Program Kit D2-3...
  • Page 7 Preface Read this manual carefully before installation, use and service of this product. Replace the manual immediately if lost. Nederman reserves the right, without previous notice, to modify and improve its products including documentation. This product is designed to meet the requirements of relevant EC directives. To maintain this status, all installation, maintenance and repair is to be done by qualified personnel using only original spare parts.
  • Page 8: Intended Use

    In a standard Nederman installation, all transmitters from the factory are programmed to send a Nederman unique signal to the receiver to start the fan for that system. However, if a vehicle from another Nederman installation comes within 50 meters of the receiver, the transmitter in that vehicle will also send a signal to the receiver, which will start the fan.
  • Page 9 Fan Start/Stop Device Program Kit D2-3 Double click to open the driver, ‘file.rar’ (for example ‘CDM20814_Setup-2.rar’), and follow its instructions to install the driver. When the programming device is ready, the LED (Green) is lit, see Figure 2(B). Reprogram a transmitter Follow the procedure below to reprogram a transmitter using the Programming Kit D2-3: Unscrew and remove cover from the back of a transmitter, see Figure 3(A): •...
  • Page 10: Spare Parts

    Spare parts Contact your nearest authorized distributor or Nederman for advice on technical service or if you require help with spare parts. See also www.nederman.com. When ordering spare parts always state the following: •...
  • Page 12 www.nederman.com...

This manual is also suitable for:

MagnastackMagnarail